"I can't believe how much our house has changed! The comments we get from guests and friends are unending; you sure came through with your system!"

~ Carrie & Dave S.
Winter Garden, FL

A few pointers in making corners:

Depending on whether or not you have a table saw that will cut at a 45 degree angle, the mitered joint will give you the best results.  If you don't have this saw available, then the butt joint method will still give you reasonable results.  There are basically two type of corners, 3a - outside corner and 3b - inside corner. In either case, we recommend that you glue the joints in place with the proper glue .

The two images below show a cross section of both methods.  The big advantage with the miter joint is that it allows a greater surface area for the glue.  Secondly although it may be harder to cut, it is much easier to sand down and totally hide the seam.

The butt joint method will work just as well, but allow a little more time to sand down the seam.

If you still see a slight seam, don't feel bad, not all walls are at 90 degree angles.  A little spackling or caulking is all it takes.  

back to top

Wainscot Products

Questions?

Email Address:

Message: Message:

* We do not share or sell your personal information. Your personal information and or email address is used strictly for replying to your questions and comments, as well as informing you of any additional information.